CETME Model L

0 comments

CETME Model L

The CETME Model L is a Spanish 5.56mm assault rifle developed in the late 1970s at the state-owned small arms research and development establishment CETME (Centro de Estudios Técnicos de Materiales Especiales) located in Madrid. The rifle retains many of the proven design elements the institute had used previously in its Model A, B and C series of battle rifles.

The weapon was successfully trialled between 1981–1982 and approved for serial production in 1984 at the Empresa Nacional Santa Bárbara factory (currently Santa Bárbara Sistemas, integrated into General Dynamics European Land Combat Systems division). The Model L replaced the 7.62mm CETME Model C in service with the Spanish Army and the first rifles were delivered in 1987, by which time orders for approximately 60,000 had been placed. It has now been largely replaced in Spanish service with a license-built variant of the Heckler & Koch G36E.

Model L
Type Assault rifle
Place of origin Spain
Service history
In service 1987–1999
Used by Spain
Production history
Designer CETME
Designed 1981
Manufacturer CETME
Produced 1986–1991
Variants Model LC, Model LV
Specifications
Weight 3.4 kg (7.5 lb) (Model L)
3.55 kg (7.8 lb)
Length 925 mm (36.4 in) (Model L)
860 mm (33.9 in) stock extended / 665 mm (26.2 in) stock collapsed (Model LC)
Barrel length 400 mm (15.7 in) (Model L)
320 mm (12.6 in) (Model LC)

Cartridge 5.56x45mm NATO
Action Roller-delayed blowback
Rate of fire 600–750 rounds/min (Model L)
650–800 rounds/min (Model LC)
Muzzle velocity 875 m/s (2,871 ft/s) (Model L)
832 m/s (2,729.7 ft/s) (Model LC)
Effective range 200–400 m sight adjustments
Maximum range 400 m
Feed system 12, 20, 30-round STANAG magazine
Sights Front: shrouded post, rear: flip-up sight with two apertures
440 mm (17.3 in) sight radius

Operating mechanism

The Model L is a selective fire, roller-delayed blowback firearm. The weapon features a semi-rigid two-piece bolt mechanism that consists of a bolt head and a supporting angular locking piece. During the "unlocking" sequence, the two cylindrical rollers contained in the bolt head are cammed inward against inclined flanks of the barrel extension and act upon the locking piece and bolt carrier, propelling it rearward at a velocity greater than that of the bolt, which remains closed until the fired bullet has left the barrel and pressures inside the bore have been reduced to a safe level before withdrawing together with the bolt carrier.

Features

The bolt also has a cartridge casing extractor, while the ejector is located inside the trigger housing (the extractor is lifted by the recoiling bolt carrier, actuated with every shot). The weapon is hammer-fired and has a fire control lever, which is also the manual safety. The safety and fire selector lever is located on the left side of the receiver, directly above the pistol grip, and has three settings: "S"—weapon safe (trigger is disabled mechanically), "T"—semi-automatic fire and "R"—fully automatic fire (initial production rifles also had a burst selector option, which was abandoned). The Model L fires from a closed bolt position and uses the NATO-standard 5.56x45mm cartridge loaded with the 62-grain SS109 projectile. INI (Instituto Nacional de Industria, a state factory) made ammunition was dirtier and gave much more chamber pressure than standard NATO ammunition, and was one of the sources of reliability problems (hard primers were in part responsible, too). At NATO joint exercises, foreign units tended to be warned not to use Spanish ammo if their rifles were gas operated.

The rifle's barrel features 6 right-hand grooves and a rifling twist rate of 1 in 178 mm (1:7 in); it is fitted with an open-type 3-prong flash suppressor that is additionally designed to launch rifle grenades. The weapon will also mount a knife-type bayonet.

The Model L's fixed stock, pistol grip and handguard are made of a high-strength lightweight plastic. The rifle strips down into the following components for regular maintenance and cleaning: the receiver, stock, pistol grip and trigger group, handguard, bolt, bolt carrier and recoil mechanism.

Handguards in the first several series were "square" in section, covering from magazine well to front sight. This gave some problem with heat retention, so it was changed to a round "half length" and thicker plastic handguard, over the stamped steel support piece. Almost all military rifles changed to the new handguard, but Guardia Civil rifles retained the squared version.

Feeding

The rifle feeds from standard NATO magazines that adhere to STANAG specifications (interchangeable with magazines from the M16 rifle) and have a 30-round capacity, but it can also use short 12-round box magazines, usually only used for parades (early rifles and carbines were also adapted to use special 20 and 30-round magazines that were of an entirely different design).

Issued magazines were steel, but thick walls only gave several problems, like misfeedings, stuck magazines (some could not even be inserted in the rifles), and the like. Although they were supposed to be expendable (a cost of 25 pesetas in 1995), it was forbidden to discard them, and many soldiers were punished for losing a magazine. Spanish soldiers tried to keep magazines known to work well for themselves, or get other STANAG magazines from surplus stores or friends abroad. It was a common sight in NATO joint exercises to see Spanish soldiers searching the zone where US troops discarded their empty mags. Many reliability problems were solved by using these "non--issued" magazines.

Sights

The CETME Model L is equipped with adjustable iron sights consisting of a forward post (corrected mechanically for elevation) in two versions "thick" and "thin" (no official designation). Thin post was better for precission shooting, but it could easily bend if hit. Since it was well protected this wasn't much of a problem, and it was preferred over the thicker version. A flip-up rear sight with two settings for firing at distances of 200 and 400 m (early models had a rotating drum rear sight that provided 100, 200, 300 and 400 m sighting range apertures). The Model LV (Visor) is a marksman variant equipped with a fixed STANAG mount over the rear sight base; the optic generally used in this role is the British SUSAT sight in some units, the standard being a nationally produced ENOSA. Another model with a rotating drum rear sight used by the Infanteria de Marina was also called LV, leading to some confusion, even in training manual and logistics. The standard rear sight base has an horizontal pin forward, and a circular shallow cavity behind were a detachable scope base could be mounted, but almost never used since not many of these bases were made for general use.

Accessories

Standard equipment supplied with the rifle includes a cleaning kit, sling, bayonet, lightweight bipod, blank-firing adaptor, rifle grenade launcher guide and magazine loader tool.

CETME Model L Variants

A variant of the Model L is the Model LC carbine that has a short barrel and a collapsible metal shoulder stock, making it particularly suitable for officers, special forces and riot police. These features also allow a high degree of movement in closed spaces or moving vehicles. This carbine version however cannot be used with a bayonet or rifle grenades.


Share this article :
 
Copyright © 2011. Military Weapons|Firearms|Tank|Jet Fighter|Battleship - All Rights Reserved
RSS Feeds
Powered by Military Weapons